Gas conversion
:
Changing injectors:
:
•
.
•
•
•
Caution : The following procedures must be undertaken by authorized
service people.
Your appliance is adjusted to be operated with LPG/NG gas. The gas burners
can be adapted to different types of gas, by replacing the corresponding
injectors and adjusting minimum flame length suitable to the gas in use. For
this purpose, the following steps should be performed
Hob Burners
Cut off the main gas supply and unplug from the electric mains
Remove the burner cap and the adapter(Figure 8).
Unscrew the injectors. For this, use a 7mm spanner(Figure 9).
Replace the injector with the ones from the gas conversion kit, with
corresponding diameters suitable to the type of gas that is going to be used,
according to the information chart (which is also supplied in the gas
conversion kit).
Oven/Grill Injectors
Grill Injector
The oven and grill injectors are assembled by a single screw that is placed on
the tip of the burner. For grill burners, this screw is already visible(Figure 10).
Remove the screw, pull the grill burner to yourself and you will see the injector
revealed on the rear surface of the oven cavity (Figure 11).
Oven Injector
For oven burners, open the drawer compartment and you will see the assembly
screw below the burner (Figure 12). Remove the screw, move the burner
diagonally and the injector will be revealed on the rear side of the burner box
(Figure 11).
:
:
:
Figure 8
Figure 9
Injector
Spanner
For Customer Services, Spare parts & Warranty Information please call 0845 683 8717
-12-
