You choose the full heat or half heat button depending on your fabric as on the standard timer
models.
At the end of any cycle chosen, if you are not there to unload the clothes immediately from the
dryer, the anti-crease function will begin, turning the drum occasionally to avoid creasing until
you are ready to unload the dryer and will continue until you open the door or disconnect from
the mains.
PREPARATION
Check care labels inside the garments
.
CARE LABELS YOU MAY FIND ON YOUR FABRICS
Do not tumble dry woollen or wool mixture articles unless the article is labelled as being suitable
.This should avoid shrinkage.
Place delicate articles, e.g.tights, scarves, inside a pillowcase.
To avoid the need to iron easycare polyester/cotton items it is better to only dry small loads (i.e.
half fill drum) It is better to dry small and large articles together.
Fabric softeners, or similar products, should be used as specified by the Fabric Softener
instructions. Do not overload the dryer or dry large bulky items such as duvets or sleeping bags
as it is important that the airflow through the dryer is not obstructed.
Items that have been soiled with substances such as cooking oil, acetone, alcohol, petrol,
kerosene, spot removers, turpentine, waxes and wax removers should be washed in hot water
with an extra amount of detergent before being dried in the tumble dryer.
Items such as foam rubber (latex foam), shower caps, waterproof textiles, rubber backed
articles and clothes or pillows fitted with foam rubber pads should not be dried in the tumble
dryer.
OPERATION
1. Open the door.
2. Load clothes loosely into the drum.
3. Load sheets first, starting with one corner.
4. Close the door.
5. Dry your hands.
6. Plug in the machine.
7. Choose the final dryness level of the load by selecting the desired dryness setting (see
the programme chart on the control panel).
8. Select the correct heat setting and press the start button
