DMS-3.1 Test Procedure
30
of
64
20. When you see “Please remove USB drive from Module 3,
Do as instructed and remove the BC Magic drive from Port 3 of the DMS-3.1.
Then press ‘c’ key to continue.
21. After pressing the ‘c’ key many messages will fill the Putty window.
The MAC Address is being programmed into the BridgeCo module.
The MAC Address for that module will be confirmed.
Note: If you do not remove the USB Stick for USB Module 3, then press ‘c”
you will be required to enter the MAC ID Manually.
This will be described at the end of this section.
22. Do nothing until you see the message in the next step.
========================================================
=============
=
=
= Remove USB drive from Module 3
=
= Then press the 'c' key to continue
=
=
========================================================
Summary of Contents for DMS-3.1
Page 1: ......
Page 27: ...SMS_USB_ _PWR_LED_Front_RevA_7_19_10 sch 1 Wed Jul 28 15 07 39 2010 ...
Page 116: ......
