5
LED LIGHT INSTALLATION
1. To choose the mounting location, make sure the LED light illuminates the desired
area and that the LED Solar Sensor Light will not be directly exposed to rain.
2. Depending on the mounting height (roughly at 6.5ft) the motion detector has a
detection range of max. 39.4ft with a detection angle of 140°.
3. Be sure the motion detector is not illuminated by street lighting at night.
This can influence the motion sensor.
4. Loosen the two screws on the back of main unit to release the mounting plate.
5. Use the holes on the mounting plate intended for the screws to mark the positions
for drilling.
6. Drill two holes in the mounting location, insert wall plugs and fix the mounting
plate with screws.
7. Fit the main unit onto the plate by screws.
8. Rotate and adjust the LED light to illuminate the desired area.
9. Turn the control knob TIME to adjust the duration of the illumination. The lighting
duration can be adjusted from approx. 3 seconds to 7 minutes (+/-10%).
10. Turn the control knob LUX to adjust the daylightlevel: At the position
, the motion
detector only reacts at night. In the
, the motion detector also responds at
daylight levels.
