www.Rustica.com
Version 1–2019
9
CLASSIC BARN DOOR HARDWARE
ASSEMBLY INSTRUCTIONS
A
B
C
D
ANTI-JUMP GUIDE INSTALLATION
A
Place the Anti-Jump bracket on the door side, moving the
bracket up until it is between 1/8” and 1/16” from the bottom
edge of the rail. Mark the placement with a pencil.
SUGGESTION:
Use double stick tape on the back of the anti-
jump bracket to hold it in place on the door.
B
Install the bracket to the door edge with 2 phillips screws
(provided) using a drill with a phillips bit.
Repeat steps
A
and
B
for the opposite end of the door.
ANTI-JUMP BLOCK INSTALLATION
FOR BI-PARTING DOORS
C
Place the Anti-Jump block on the top of the door.
D
Using
a drill with a phllips bit, install the the block with the 1” phillips
screw (provided).
SUGGESTION:
Use double stick tape on the back of the anti-
jump block to hold it in place on the door.
Repeat step
C
and
D
for the opposite end of the door.
