5
www.Rustica.com
TOP MOUNT LOW CLEARANCE SYSTEM
ASSEMBLY INSTRUCTIONS
INSTALLATION FOR CURVE-EDGE DOORS
Place the hanger on the top surface of the door, 2-3/4”
from the edge of the door side and flush with the door front.
Ensure the front of the hanger and the front of the door are
facing the same direction.
NOTE:
If the door is 3 or more inches thick, mount the
hanger in the center between the front and back of the door.
Using a pencil, mark the screw hole placement on the door
top. Repeat steps and for the opposite end of the door.
Drill two pilot holes for each
hanger using an 1/8” bit.
Attach the hanger to
the door using two fastener
screws (provided). Repeat the
process on the opposite end
of the door.
2-3/4”
Door Front
Door
Side
Door
Top
NOTE:
Doors using Floor Mount
Door Guides will have a groove on
the bottom. Ensure this groove is on
the opposite end of the Door Hanger
Installation.
