6
www.Rustica.com
TOP MOUNT LOW CLEARANCE SYSTEM
ASSEMBLY INSTRUCTIONS
FIRST THINGS FIRST
Check to see if the floor below the track is level. If the floor rises more than 1/2”, the door may rub or not
slide open completely. If the floor is not level, measure from the highest point of the floor surface to the
recommended track placement and adjust track placement accordingly.
Ensure the track will be installed onto wall studs. If wall studs are not lining up with the installation a header
will be required to provide the necessary strength and stability for the track and door.
TRACK & DOOR INSTALLATION
To determine where the track should be
installed, first measure the height of the door,
then add 2-7/8” to the door length. 1/2” will be
for the clearance between the bottom edge of
the door and the floor. 2-3/8” will be from the
top edge of the door to the center of the hole.
Using a level and a pencil, mark a line above the
doorway the same length as the track.
Hold the track up to where the pencil line is
visible through the holes in the track.
SUGGESTION:
Use pieces of double stick tape
on the back of the track to help hold the track in
place while completing steps and .
Mark an intersecting line inside each slotted
hole wherever they work best for your wall (i.e.
stud locations).
Take the track down, remove double stick tape (if
used) and set the track aside.
