USE AND MAINTENANCE MANUAL R68090150
ORIGINALE
RUTHMANN ITALIA S.r.l. Via Santa Maria del Piano di sotto,91/B
–
47854 Montescudo-Monte Colombo (RN) - ITALIA
pag. 51
- there is not any malfunctioning of platform that could block all boom
functions (… as breakdown of a safety sensor). In case of a
malfunctioning, the led is off and an alarm message appears on the
display of remote control. If the malfunctioning causes the block of only
a part of lifting movements, the white led continues to be on. If led is
off and there is not any alarm message on display, the operator has to
check the previous conditions and if the emergency compartment
located on the right side of platform is open.
GO HOME (OPTION)
Depress push button
“Basic position”
and deflect the left-hand joystick to the rear
for moving the ECOLINE into the rest position automatically.
The basic position is moved into automatically as long as the above-mentioned
joystick is deflected.
AUTOMATIC CENTER POSITION OF TURRET
The automated positioning aid makes it possible to bring the boom easily into its centre position in order to
facilitate lowering of the boom into its boom rest.
Before closing the machine for the transport, it is necessary to put the turret in the center position. When
operator turns the turret and it arrives closed to the center position, the software automatically stops the
rotation for few second, giving the signal that it is possible to lower booms for rest. Otherwise, if you want
to continue the rotation, move the joystick rightward or leftward.
When the tower is in the central position, the following pictogram is displayed:
!
WARNING
ATTENTION
When the boom is in rest position, but the turret is not in center position, the white led is
on and the orange led flashes.
AUTOMATIC START & STOP of engine
On RUTHMANN ECOLINE, it is possible to active the
Automatic Function of “Start &
Stop” of the petrol engine
for optimizing the consumption of the petrol and the
pollution.
During your working, if you do not make any movement after 30-40 sec. the system
switch off the engine automatically; but it is enough to move again a joystick on the
basket control box for starting again the engine.
If you switch off the engine by the ON/OFF switch placed on the remote control, you
deactivate this function.
When this function is active, on the display there is the message “S & S”:
