Rutter VDR-100G2 Operation User'S Manual Download

Page: 72 / 79

VDR-100G2/G2S Operation User Manual

RUT-UM-02-002_Rev. 2.0

7.3

Corrective Maintenance

7.3.1

Alarm Code Descriptions

Listed below are the alarm codes that may appear on the OAU LCD display:

Alarm Code

Description

System Error

Communication with the Record Application has been lost

Video Error

Communication with the Video Module has been lost

Audio Error

Communication with the Audio Module has been lost

FRM Error

Communication with the Final Recording Medium has been lost

Power Fail

Loss of utility power

PCM Error

Communication has been lost with the Power Control Module

Remote Error

Communication has been lost with the Remote Storage Module

Serial Error

Communication has been lost with the NMEA Module

Mic Error

Communication has been lost with one of the microphones

Disk Error

Failure to secure a data set

GPS Error

Data is failing to record on TimeMuxID parameters entry

Table 7-1: Alarm Code Description

Pressing the “Mute” button acknowledges the alarm code and silences the alarm. The red alarm indicator
lamp will stay illuminated until all alarm conditions are cleared. If there is more than one alarm condition,
the OAU display will cycle through the current alarm messages.

SYSTEM ERROR

: Turn the ship breaker for the VDR/SVDR power OFF. Wait 2 hours and 15 minutes.

Turn the VDR/SVDR power breaker back on and see if this has cleared the error.

If error returns, get

service to find and repair the error.

VIDEO ERROR:

Open Data Processing Unit (DPU) (the VDR/SVDR’s main cabinet) and ensure that the

2 AMP DC breaker inside marked

Video/NMEA

is closed. Make sure the Ethernet cable plugged into the

VDR/SVDR’s computer port marked

Video/NMEA

is pressed all the way into this port. There should be a

solid green link light and a flashing yellow light associated with this port. Locate the video module and
ensure it’s red LED power lights are lit and that its Ethernet cable is securely inserted in the modules
Ethernet port.

If error returns, get service to find and repair the error.

AUDIO ERROR:

Open Data Processing Unit (DPU) (the VDR/SVDR’s main cabinet) and ensure that the

2 AMP DC breaker inside marked

Audio/Alarm

is closed. Make sure the Ethernet cable plugged into the

VDR/SVDR’s computer port marked

Audio

is pressed all the way into this port. There should be a solid

green link light and a flashing yellow light associated with this port. Locate the audio module and ensure
it’s red LED power lights are lit and that its Ethernet cable is securely inserted in the modules Ethernet
port.

If error returns, get service to find and repair the error.

FRM ERROR:

Open Data Processing Unit (DPU) (the VDR/SVDR’s main cabinet) and ensure that the 2

AMP DC breaker inside marked

FRM

is closed. Make sure the Ethernet cable plugged into the

VDR/SVDR’s computer port marked

FRM

is pressed all the way into this port. There should be a solid

green link light and a flashing yellow light associated with this port. If problem still exists; open the FRM 2-
AMP breaker by pressing its

Red Button

, wait 5-seconds and close this breaker by pressing its

Black and

White Button marked with the number 2

If error returns, get service to find and repair the error.

PCM ERROR:

Open Data Processing Unit (DPU) (the VDR/SVDR’s main cabinet) and ensure that the

two serial connectors on the back of the computer are still firmly in place. If problem persists turn the ship
breaker for the VDR/SVDR power OFF. Wait 2 hours and 15 minutes. Turn the VDR/SVDR power
breaker back on and see if this has cleared the error.

If error returns, get service to find and repair the

error.