VDR-100G2/G2S Operation User Manual
48
RUT-UM-02-002_Rev. 2.0
Figure 6-15 – Audio Menu
There are two (2) ways to activate an available audio channel individually:
Select the appropriate audio channel from the ‘Audio’ file menu, or,
Click the ‘Active’ checkbox below the appropriate channel once the audio has been unlocked.
It is also possible to print the audio status to the ‘Log’ Tab Screen by selecting ‘Status’ from
the ‘Audio’ file menu.
To silence a playback, simply uncheck each channel either on the ‘Audio’ menu or via the ‘Active’
checkbox.
6.9
Conning Tab Screen
The Conning Data Tab is the default screen upon Playback start-up. In addition to the Propulsion and
Video Channel(s) (for example, PORT X-Band, STBD S-Band, and CCTV) information tab(s) found in the
centre of the screen, the Conning Data Tab also contains the following information (all along the upper
left hand side of the tab screen):
Date – Date of playback information
Time – Time of playback information
Latitude – Ship’s latitude
Longitude – Ship’s longitude
GPS Mode – Global Positioning System: SPS, DGPS (Differential GPS), PPS, RTK (Real
Time Kinematic), FRTK (Float Real Time Kinematic), and DRM (Dead Reckoning Mode)
Heading – Ship’s heading
Autopilot – Indicates the presence or non-presence of a heading control system (On/Off)
COG – Ship’s Course Over Ground
SOG – Ship’s Speed Over Ground
Depth – Depth of ship
ROT – Ship’s Rate Of Turn
6.9.1
Depth Graph
The Depth Graph provides an illustration, in metres (m), of the ship’s depth.
Figure 6-16 - Depth Graph
Summary of Contents for VDR-100G2
