12
13
4. Connect wires to the
thermostat terminal
Note the wire color used for each
terminal; it’s good practice to use the
same wire color on identical termination
points on the indoor and outdoor units.
5. Attach display
to mounted
wall plate
6. Turn power on
Power system back on and let the
EcoNet Smart Thermostat auto-
configure your equipment.
Full Instructions
RECOMMENDED:
Scan the QR
code below using your mobile device
to view the full instructions.
FCC Compliance Statement
Compliance Notice – This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of FCC rules
Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.
Change or modifications that are not expressly approved by the manufacturer could void the user’s authority to
operate the equipment.
QUICK S
TART
GUIDE
E1
E2
C
R
R
E1
E2
S1
S2
C
R
E1
E2
C
OUTDOOR UNIT
INDOOR UNIT
OPTIONAL REMOTE
TEMPERATURE SENSOR
ECONET
SMART THERMOSTAT
R C S1 S2 E1 E2
QUICK S
TART
GUIDE
E1
E2
C
R
R
E1
E2
S1
S2
C
R
E1
E2
C
OUTDOOR UNIT
INDOOR UNIT
OPTIONAL REMOTE
TEMPERATURE SENSOR
ECONET
SMART THERMOSTAT
R C S1 S2 E1 E2
Tip:
When installed correctly, the
release lever of the terminal block will
lower to indicate engagement.
