Troubleshooting
Monitor Displays Blue Screen & Displays No Signal
•
Do a hard reset, unplug all
cables and power cables leave
out for 1 minute and then
re-connect them.
•
Check to ensure that the con
nection to the camera is tight.
•
Verify camera cable is plugged
into port labeled Backup Camera
•
Verify that the blue positive
trigger on power harness is put to
power 12v+.
If the problem still persists, verify
that alternate ports work. If
alternate ports do not work,
remove Blue Trigger wire from 12V+
and select alternate channels.
Monitor Will Not Power-Up (no backlight on power button)
•
Check fuse
•
Check ground connection
•
Check 12v+ to monitor
No Image On Screen
•
Verify camera is on correct
camera input
•
Verify cable is connected to
monitor
•
Verify camera is connected to
cable
•
Connect known working
camera and cable to monitor.
•
Verify Blue trigger is receiving
power
Audio On Camera
•
Verify chosen camera has audio
•
Verify volume setting
•
Confirm that the Blue audio
Trigger is connected to 12v+
NOTE: This guide references backup cameras. These cameras are sold separately.
13
Summary of Contents for 7709910
Page 1: ...7 WATERPROOF REAR VIEW MONITOR RVS 9910 Instruction Manual VEHICLE SAFETY IT S ALL WE DO TM...
Page 7: ...Installation Diagram Figure 1 1 Figure 1 3 Connection of U Bracket Figure 1 2 11 C t t S 7...
Page 8: ...Installing the Monitor Camera Sold Separately 8...
Page 11: ...Monitor Dimensions 205 50 mm CJDDDDD il s s 11...
