Installation, operating and maintenance manual SKIT/S-DEB
3rd print version
page 13
2 – General safety notes
RWO GmbH
●
Marine Water Technology
●
Bremen
●
Germany
Issue 2014-04-10
2.6
Basic information on personal protection equipment (PPE)
Change your clothes before performing any kind of
maintenance or other work at the unit.
Wear:
Disposable single-use boiler suits
Rubber boots
Rubber coated textile gloves
Eye protection
Safety harnass
After work, dispose of the single-use clothes
properly and clean the other parts with fresh water
before storing them.
2.7
Observe the environmental regulations
Legal regulations for e. g. avoiding waste have to be taken
into consideration during all works carried out at the plant /
unit.
Especially during installation, repair and maintenance
works, water endangering materials such as:
·
lubricants and oils
·
hydraulic oil
·
coolants
·
acids and lyes
·
cleaning agents
are not to be discharged into the soil or the drain!
These substances must be collected in suitable tanks,
transported and disposed of according to valid regulations!
2.8
Risk potential of the bilge water oil separator
The bilge water oil separator has been subject to a safety
inspection and acceptance test. Faulty operation or
misuse may result in severe health risks for the user and
damage to the environment. Additionally, the bilge water
oil separator and other assets of the ship can suffer
permanent damage.
All persons involved in the installation, the electric and
hydraulic connection and the operation of the bilge water
oil separator must be qualified accordingly (the relevant
training sessions can be booked in our service department
(
à
1.5 Contact information)) and must pay close attention
to these installation and operating instructions.
Your safety is concerned!
