HEAVY DUTY
SOD CUTTER
20
MAINTENANCE / SERVICE
When replacement parts are required, use genuine
Schiller Grounds Care, Inc.
parts or parts with
equivalent characteristics, including type, strength
and material. Failure to do so may result in
product malfunction and possible injury to the
operator and/or bystanders.
Carbon monoxide present in the exhaust is an
odorless and deadly gas. Never start or run the
engine inside where exhaust fumes can collect.
Provide enough fresh air to keep fumes from getting
too strong.
Replace any warning decal that becomes illegible
immediately.
DAILY MAINTENANCE
Operator Presence System
For the engine to run, the Operator Presence
Lever must be held when the Master Clutch
Control is engaged.
To Check:
1. Start the engine and run at 1/2 throttle with the
master clutch disengaged.
2. Engage the master clutch holding the Operator
Presence Lever. Release the operator presence
lever and the engine should stop.
Repair the machine before using if the Operator
Presence System does not kill the engine.
Blades:
Check for damage. Replace any broken,
cracked or otherwise damaged blades. Do not
weld or straighten blades. Replace or sharpen
dull blades. See Sharpening Instructions.
Hardware:
Tighten any nuts and bolts that are found loose.
Replace any broken or missing cotter pins.
Repair any other problems before operating.
Engine:
See engine manual for change intervals and oil
specifications. See engine manual for air cleaner
service intervals and service procedure.
4163592
ROTATING PARTS:
Entanglement / Amputation Hazard
Do not operate with cover removed.
Stop engine before servicing.
ATTENTION:
-Read Operator Manual before servicing or
repairing.
-Remove spark plug wire before servicing or
repairing.
Use adequate lifting device (i.e., hoist, fork lift, etc.)
to raise unit.
Use adequate supports when unit is raised for
servicing.
Wear protective eye equipment when using
hammers, chisels and punches.
Summary of Contents for 544853G
Page 2: ......
