7
HEAVY DUTY
SOD CUTTER
LABELS
OPERATING INSTRUCTIONS
TRANSPORTING MACHINE
TO MOVE WITHOUT POOWER:
PLACE DRIVE WHEEL SHIFTER LEVER (IN CENTER OF GEAR CASE COVER) IN CENTER “N” (NUETRAL) POSITION.
TO MOVE MACHINE UNDER POWER:
1. DISENGAGE CUTTING BLADE SHIFTER LEVER (ON REAR RIGHT SIDE OF MACHINE) BY ROTATING DOWNWARD.
2. SET DRIVE WHEEL SHIFTER LEVER (IN CENTER OF GEAR CASE COVER) TO THE “H” OR HIGH SPEED POSITION.
3. WITH THE ENGINE RUNNING, HOLD OPERATOR PRESENT LEVER AGAINST HANDLEBAR AND PUSH CLLUTCH LEVER
FORWARD TO THE ENGAGED POSITION.
STARTING ENGINE
1. FILL FUEL TANK WITH REGULAR GASOLINE.
2. PULL CLUTCH LEVER BACK TO DISENGAGED POSITION.
3. SET THROTTLE TO 1/2 OPEN POSITION.
4. SET CHOKE AND START ENGINE.
SOD CUTTING INSTRUCTIONS
1. MAKE REQUIRED BLADE ADJUSTMENTS.
2. START ENGINE PER INSTRUCTIONS ABOVE AND SET THROTTLE TO FULL SPEED.
3. ENGAGE DRIVE WHEELS BY PLACING SHIFTER LEVER (IN CENTER OF GEAR CASE COVER) TO “L” OR LOW.
4. ENGAGE CUTTING BLADE BY ROTATING SHIFTER LEVER ON REAR RIGHT SIDE OF MACHINE UPWARD.
5. WITH MACHINE TIPPED FORWARD ON FRONT BUMPER AND OPERATOR PRESENT LEVER HELD AGAINST HANDLEBAR, PUSH CLUTCH LEVER FORWARD,
AT THE
SAME TIME LOWER THE MACHINE SO BLADE ENTERS THE GROUND.
6. TO STOP MACHINE, PULL BACK FIRMLY ON CLUTCH LEVER, THIS APPLIES A BRAKE.
7. STOP ENGINE BY MOVING THROTTLE LEVER TO “OFF” POSITION.
524540
Summary of Contents for 544853G
Page 2: ......
