Ryobi 6210739, Original Instructions Manual

3

tongs to avoid getting the nozzle close to your fingers.

■

Allow the glue stick and glue gun nozzle to completely 
cool before removing the battery pack.

TRANSPORTING LITHIUM BATTERIES

Transport the battery in accordance with local and national 
provisions and regulations.
Follow all special requirements on packaging and labelling 
when transporting batteries by a third party. Ensure that 
no batteries can come in contact with other batteries 
or conductive materials while in transport by protecting 
exposed connectors with insulating, non-conductive caps 
or tape. Do not transport batteries that are cracked or 
leaking. Check with the forwarding company for further 
advice.

KNOW YOUR PRODUCT

See page 5.

1.  Nozzle

2.  Glue stick chamber

3.  LED on/off indicator

4.  On/Off switch

5.  Switch trigger

6.  Battery port

7.  Glue stick

MAINTENANCE

 WARNING

The product should never be connected to a power 
supply when assembling parts, making adjustments, 
cleaning, performing maintenance, or when the product 
is not in use. Disconnecting the product will prevent 
accidental starting that could cause serious injury.

■

When servicing, use only identical replacement parts. 
Use of any other parts may create a hazard or cause 
product damage.

■

Avoid using solvents when cleaning plastic parts. Most 
plastics are susceptible to various types of commercial 
solvents and may be damaged by their use. Use clean 
cloths to remove dirt and carbon dust.

■

Do not, at any time, let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact 
with plastic parts. They contain chemicals that can 
damage, weaken, or destroy plastic.

■

Always wear safety goggles or safety glasses with side 
shields during power tool operation or when blowing 
dust. If operation is dusty, also wear a dust mask.

■

For greater safety and reliability, all repairs should be 
performed by an authorised service centre.

ENVIRONMENTAL PROTECTION

Recycle raw materials instead of disposing 
of as waste. The machine, accessories, and 
packaging should be sorted for environment-
friendly recycling.

SYMBOLS

Safety alert

Regulatory Compliance Mark (RCM). 

Product meets applicable regulatory 

requirements.

Please read the instructions carefully 

before starting the machine.

V

Volts

Direct current

To reduce the risk of injury or damage, 

avoid contact with any hot surface.

Hot surface

Waste electrical products should not 

be disposed of with household waste. 

Please recycle where facilities exist. 

Check with your local authority or 

retailer for recycling advice.

SYMBOLS IN THIS MANUAL

Note

5s

Waiting time

The following signal words and meanings are intended to 
explain the levels of risk associated with this product: