12
WARNING:
Battery tools are always in operating condition. Therefore,
switch should always be locked when not in use orcar-
rying at your side.
SANDING SHEET AND PAD SELECTION
Selecting the correct size grit and type sandpaper is an
extremely important step in achieving a high quality sanded
finish. Aluminum oxide, silicon carbide and other synthetic
abrasives are best for power sanding. Natural abrasives,
such as flint and garnet, are too soft for economical use in
power sanding.
In general, coarse grit will remove the most material and finer
grit will produce the best finish in all sanding operations. The
condition of the surface to be sanded will determine which
grit will do the job. If the surface is rough, start with a coarse
grit and sand until the surface is uniform. Medium grit may
then be used to remove scratches left by the coarser grit
and finer grit used for finishing of the surface. Always
continue sanding with each grit until surface is uniform.
Sheet/Pad
Recommended Use
Heavy scrubbing pad
Paint and rust removal
(Part no. 019001001026)
Light scrubbing pad
Light scrubbing and cleaning
(Part no. 019001001027)
Polishing pad
Polishing
(Part no. 019001001028)
60-grit sanding sheet
Coarse sanding
(Part no. 019001001023)
120-grit sanding sheet
Light sanding
(Part no. 019001001024)
240-grit sanding sheet
Finish sanding
(Part no. 019001001025)
WARNING:
Always remove the battery pack when attaching, chang-
ing or rotating sanding sheets. Failure to do so could
cause accidental starting, leading to serious personal
injury.
ATTACHING SANDING SHEETS, SCRUBBING
PADS AND POLISHING PADS
See Figure 4.
n
Align the pointed tip and rounded edges of the sanding
sheet or pad with the pointed tip and rounded edges of
the hook-and-loop pad. Carefully press the fuzzy side of
the sanding sheet against the pad as tightly as possible.
NOTE:
Sanding sheets can be reused for the life of the
sanding abrasive. It is recommended that you keep the
sanding sheet backing pad clean to provide for best
adhesion. Clean occasionally by brushing lightly with a
small brush.
Fig. 5
Fig. 4
OPERATION
TURNING THE SANDER ON (I) / OFF (O)
See Figure 5.
n
Install the battery pack.
n
To turn ON the sander: push the ON (I) / OFF (O) switch
to the left.
n
To turn OFF the sander: push the ON (I) / OFF (O) switch
to the right.
HOOK-AND-LOOP
PAD
SANDING SHEET
FUZZY SIDE
ON (I) / OFF (O) SWITCH
ON (I)
OFF (O)
Summary of Contents for CCC180L
Page 16: ...16...