5
FEATURES
KNOW YOUR SCREW DRIVER
Fig.1
OPERATING INSTRUCTIONS
CHARGING YOUR SCREW DRIVER
Fig. 2
A. CHARGER
B. CHARGER PLUG
C. INPUT JACK
A. ON/OFF, FORWARD/REVERSE SWITCH
B. TORQUE ADJUSTMENT RING
C. COLLET
D. CLUTCH RING COVER
This tool has been shipped in low charge condition to
prevent possible problems. Therefore, you should charge
it overnight prior to use.
Note: Batteries will not reach full charge the first time
they are charged. Allow several cycles (drilling followed
by re-charging) for them to become fully charged.
Note: Only use the charger provided.
Connect charger to the tool by inserting charger plug
into input jack. Make sure the power supply is normal
household voltage, 240V, 50Hz, AC only.
Connect charger to power supply.
After normal usage, a minimum charge time of
3-5 hours is required to recharge a completely
discharged battery.
The charger housing and the tool handle will become
slightly warm to the touch while charging. This is
normal and does not indicate a problem.
DO NOT operate driver while it is connected to the
charger. The driving ability will not increase.
DO NOT place charger in an area of extreme heat
of cold. It works best at normal room temperature.
TORQUE ADJUSTMENT
Fig. 3
A. TO DECREASE TORQUE
B. TO INCREASE TORQUE
C. TORQUE ADJUSTMENT RING
The torque is adjusted by rotating the torque adjustment ring.
The torque is greater when the torque adjustment ring is
set on higher setting and less when set on a lower.
Rotate the adjustment ring to the desired setting.
ON / OFF, FORWARD/REVERSE SWITCH
Fig. 4
A. ON/OFF, FORWARD/REVERSE SWITCH
Depress to start and release to stop your driver.
CHANGING DRIVER ROTATION
Fig. 5
A. UP(FORWARD)
B. DOWN (REVERSE)
To insert a screw, depress the up arrow.
To remove a screw, depress the down arrow.
REMOVING BATTERIES
Fig. 6
A. HANDLE HOUSING
B. GEAR BOX HOUSING
To remove the batteries ensure that your driver is
disconnected from the charger.
Drive out the four screws that connect the gearbox
housing and handle housing and pull off the gear box.
Loosen the two screws that connect the handle to the
motor housing.
Loosen the three screws holding the handle housing.
Open the handle and take out the battery only when it
is time for disposal.
OPERATING INSTRUCTIONS
WARNING
Upon removal, cover the battery terminals with
heavy duty adhesive tape. Do not attempt to
destroy or disassemble batteries or remove any of
its components. Nickel-cadmium batteries must
be recycled or disposed of properly.Also never
touch both terminals with metal objects and/or
body parts as short circuit may result. Keep away
from children. Failure to comply with these
warnings could result in fire and/or serious injury.
BATTERY DISPOSAL
To preserve natural resources please recycle or dispose
of the battery properly.
The charger must be turned off and unplugged after 8
hours. The charger does not turn itself off. If left turned
on for more than 8 hours, damage will occur to the
battery cells or charger which is not covered under
warranty.
