into place by turning clockwise. Ensure that the
cartridge clicks into place.
NOTE:
Hitting hard and abrasive objects; such as
fences, concrete and rocks within and around long
grass may caus the cutting line to disappear and
break off within the cartridge. The cutting line can
easily be withdrawn from within the cartidge by
following these simple instructions.
(a)
Take the full
cartridge out of the black
cartridge cover.
(b)
Remove the inner
white cartridge ring
ensuring that the cutting
line does not unwind
within the cartridge by
placing fingers and thumb
on the cutting line.
(c)
Feed one end of the
cutting line into the top
slot of the cartridge ring
and the other end into the
bottom slot. Replace the
inner cartridge ring back
on to the cartridge.
(d)
Feed the two (2)
cutting lines through the
eyelets of the black cover
and press cutting line
cartridge into place within
the black cover.
(e)
Replace cutting line
cartridge as shown in
figures 10 & 11.
CUTTING LINE ADVANCE
Short or worn lines cut
less efficiently. To improve
it’s operation on subse-
quent occasions, tap the
spool button lightly on the
ground while the trimmer
is running at full speed.
This will automatically feed extra cutting line (Fig 15).
The cutting line blade situated under the guard will
automatically trim the cutting line to the correct
length during operation.
INSTRUCTIONS FOR USE
• Start the trimmer before getting close to the
grass to be cut.
• Cut the grass by moving the trimmer from right to
left and proceed slowly, keeping trimmer inclined
about 30°. High grass should be cut in layers,
always beginning from the top. The cuts should
be short.
• Do not cut damp or wet grass.
• Avoid wearing the line out quickly by knocking
against hard objects (stones, walls, fences etc).
Use the edge of the guard in order to keep the
trimmer at the right distance.
EXTENSION CORDS
You should only use extension cords for outdoor use,
PVC ordinary duty with a cross sectional area not
less than 0.72mm
2
.
Before using, check the supply and extension cords
for signs of damage or aging. If the cord becomes
damaged during use, disconnect the cord from the
supply immediately. DO NOT TOUCH THE CORD
BEFORE DISCONNECTING THE SUPPLY. Do not use
the appliance if the cord is damaged or worn. Keep
extension cord away from cutting elements.
5
Fig 15
WARNING: Do not use “Excessive Force”
or “Bash” the Trimmer Bump Head on the
ground to advance the trimming line. If the
trimming line will not advance after
tapping the bump head on the ground while the
trimmer is running, the cutting line may have tangled
or have disappeared within the cartridge, or the cut-
ting line may have been used. NOTE: “Excessive
Force” or “Bashing” the Trimmer Bump Head on the
ground to advance the cutting line will damage the
bump head.
NOTE: This damage will not be covered under
RYOBI Power Equipment Guarantee.
WARNING: The cutting head continues
to rotate after the motor is switched off
for a few seconds.
WARNING: Always ensure that the
ventilation openings are kept clear of
debris
