19 - English
Fig. 25
Fig. 23
Front of
Power Head
Front of
Power Head
Nut
Nut
Bracket
Stud
Stud
Stud
Stud
Remove the tape securing the Wi-Fi antenna and raise it
to an upright position to ensure the best Wi-Fi signal.
NOTE:
Ensure that the antenna is screwed into the power
head securely.
Place the sprocket onto the motor shaft with the round
side of the sprocket facing up.
Hold the rail assembly above the power head with arrow
pointing toward the front of the power head and the
garage door.
Rotate the rail assembly until the opening in the rail is
aligned with the sprocket.
Lower the end rail onto the sprocket with the channel
(open end) facing down. Slowly rotate the rail to the
correct orientation as you lower it into position.
When installed correctly, the teeth on the sprocket should
engage the rail assembly and the rail should sit flat on the
power head.
Place the brackets on top of the studs, and over the end
rail.
Place nuts onto the studs and tighten using a 7/16 in.
socket.
Do not overtighten.
Wi-Fi
Antenna
Wi-Fi
Antenna
Sprocket
Fig. 24
ASSEMBLY
