32 - English
INSTALLING THE INDOOR KEYPAD
See Figures 57 - 61.
The instructions below are for installing a wired indoor keypad.
To install a wireless indoor keypad, refer to the instructions
included with your wireless indoor keypad manual (GDA401).
Locate the following items:
Indoor Keypad
Low Voltage Wire
Insulated Staples (approx. 14)
Entrapment Label
Screws (1 in., Phillips Hd.) [2]
Drywall Anchors (2)
WARNING:
Do not use garage door opener if keypads or remotes
do not start and stop the motor. An opener that cannot
be controlled with a keypad or remote is dangerous,
can result in death or serious personal injury, and must
be repaired.
WARNING:
Make sure the keypad is mounted high enough to prevent
unauthorized activation of the garage door opener. It
should be placed at least five feet above the floor so that
it is inaccessible to children. Unauthorized activation of
the opener can result in death or serious personal injury.
WARNING:
Do not start or stop the garage door opener if there is a
person or object in the path of the door, the door has not
been properly balanced, or if you cannot see the doorway.
Failure to follow these instructions can result in death or
serious personal injury.
WARNING:
To avoid the risk of death, electric shock, or serious
personal injury ensure that the garage door opener is
unplugged and the battery pack is removed before wiring
the keypad.
WARNING:
Connect the keypad using low voltage wires provided
only to prevent the risk of electric shock or serious
personal injury.
Find desired location indoors and in sight of the garage
door.
NOTE:
The keypad should be at least five feet above the
floor so it is inaccessible to children.
Fig. 56
Twist the white wires from both sensors together and
insert them into the left terminal marked with W.
For alignment instructions, see
Aligning The Safety
Sensors
later in this section.
Wire Terminal
(Door Sensor)
Wires
(White)
Wires
(Striped)
“W”
“G”
Tab
Back
Cover
Fig. 57
INSTALLATION
