36 - English
Child can become trapped or pinned under an automatic gara
ge door resulting
in serious injury or death.
• Do not allow children to walk or run under a closing door.
• Do not allow children to operate door opener controls.
• Always keep a closing door within sight.
• In the event a person is trapped under the door, push the c
ontrol button or
use the emergency release.
• This operator system is equipped with an unattended opera
tion feature. The
door could move unexpectedly. Not intended for use with s
ingle panel garage
doors.
Test door opener monthly:
• Refer to Operator’s Manual.
• Use a 1 ½ inch thick object (or 2 X 4 laid flat) placed on th
e floor under the
closing door.
• In the event the door does reverse upon contact, adjust, re
pair, or replace the
opener.
Do not remove or paint over this label.
Mount this label next to the wall control.
Mount the wall control out of the reach of children at least 5 f
eet above the floor.
INSTALLATION
Fig. 66
Safety Sensor
(Receiver)
Safety Sensor
(Receiver)
Safety Sensor
(Transmitter)
Child can become trapped or pinned under an automatic gara
ge door resulting
in serious injury or death.
• Do not allow children to walk or run under a closing door.
• Do not allow children to operate door opener controls.
• Always keep a closing door within sight.
• In the event a person is trapped under the door, push the c
ontrol button or
use the emergency release.
• This operator system is equipped with an unattended oper
ation feature. The
door could move unexpectedly. Not intended for use with s
ingle panel garage
doors.
Test door opener monthly:
• Refer to Operator’s Manual.
• Use a 1 ½ inch thick object (or 2 X 4 laid flat) placed on th
e floor under the
closing door.
• In the event the door does reverse upon contact, adjust, re
pair, or replace the
opener.
Do not remove or paint over this label.
Mount this label next to the wall control.
Mount the wall control out of the reach of children at least 5 f
eet above the floor.
To align the safety sensors:
loosen, but do not remove,
the fasteners securing the sensors in place and adjust the
position of the sensors until the lens on the transmitter
and receiver are directly facing one another.
After the sensors have been aligned, retighten fasteners.
When the sensor lenses are in the correct position,
the invisible light beam emitted by the transmitter will
be captured by the receiver and the LEDs will shine
continuously.
NOTE:
If an object crosses the path of the beam, an open
garage door will not close and a closing garage door
should stop and reverse to the fully open position.
Aligning the safety sensors for multiple doors:
When multiple garage door openers are installed, extra care
must be taken to prevent misalignment and crossed signals
between each set of sensors.
Where possible, install transmitting safety sensors on an
adjacent surface facing away from each other and toward
the recievers.
Connect the garage door opener to an AC power supply.
NOTE:
Make sure the power supply is normal household
voltage, 120 volts, AC only, 60 Hz
Align each set of sensors as described earlier.
