Ryobi ONE+ 6, Original Instructions Manual

4

order of battery port numbers.
Make sure the power supply is normal household voltage, 

220 V – 240 V, 50Hz, AC only.

NOTE:

 After charging is complete, the green LED will 

remain on until the battery pack is removed from the 

charger or charger is disconnected from the power supply.
The battery pack will become slightly warm to the touch 

while charging. This is normal and does not indicate a 

problem.
Do not place the charger and battery pack in an area of 

extreme heat or cold. They will work best at normal room 

temperature.

NOTE:

 The charger and battery pack should be placed in 

a location where the temperature is more than 10°C but 

less than 38°C.

CHARGING A HOT BATTERY PACK

When using a tool continuously, the batteries in the battery 

pack will become hot. You should let a hot battery pack 

cool down for approximately 30 minutes before attempting 

to recharge.

MAINTENANCE

■

If the supply cord is damaged, it must be replaced by 

the manufacturer, its service agent or similarly qualified 

persons in order to avoid a hazard.

■

Remove the plug of the product from the power socket 

when it is not in use or when cleaning it.

■

Avoid using solvents when cleaning plastic parts. Most 

plastics are susceptible to various types of commercial 

solvents and may be damaged by their use. Use clean 

cloth or soft brush to remove dirt, dust, etc.

■

Do not at any time let brake fluids, gasoline, petroleum 

based products, penetrating oils, etc., come in contact 

with plastic parts. They contain chemicals that can 

damage, weaken or destroy plastic.

 WARNING

Hazardous voltages are present within this product; do 

not disassemble.

■

There are no user service or replacement parts inside 

this product. In case of damage or failure please 

return to your authorised RYOBI service centre for 

professional repair.

ENVIRONMENTAL PROTECTION

Recycle raw materials instead of disposing 

of as waste. The machine, accessories and 

packaging should be sorted for environment-

friendly recycling.

SYMBOLS ON THE PRODUCT

Safety alert

Class II equipment

Regulatory Compliance Mark (RCM). 

Product meets applicable regulatory 

requirements.

Please read the instructions carefully 

before starting the machine.

For indoor use only.

Time-lag fuse 3.15A

Waste electrical products should not be 

disposed of with household waste. Please 

recycle where facilities exist. Check with 

your local authority or retailer for recycling 

advice.

SYMBOLS IN THIS MANUAL

Connect to the power supply

Disconnect from the power supply

Parts or accessories sold separately

The following signal words and meanings are intended to 

explain the levels of risk associated with this product:

 DANGER

Indicates an imminently hazardous situation, which, if not 

avoided, will result in death or serious injury.

 WARNING

Indicates a potentially hazardous situation, which, if not 

avoided, could result in death or serious injury.

 CAUTION

Indicates a potentially hazardous situation, which, if not 

avoided, may result in minor or moderate injury.

CAUTION

(Without Safety Alert Symbol) Indicates a situation that 

may result in property damage.