Ryobi P307, Operator'S Manual

7 — English

NOTE: ILLUSTRATIONS START ON PAGE 8 AFTER  

FRENCH AND SPANISH LANGUAGE SECTIONS.

 WARNING:

When servicing, use only identical replacement parts. Use 
of any other parts could create a hazard or cause product 
damage.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most plastics 
are susceptible to damage from various types of commercial 
solvents and may be damaged by their use. Use clean cloths 
to remove dirt, dust, oil, grease, etc.

STORAGE

Allow the glue gun to cool completely before storing. Turn 
the switch to the off

position and remove the battery pack.

 WARNING:

Always remove the battery pack before storage to ensure 
the product is off. Allow a minimum of 30 minutes of cool-
down time before storage. Storing a glue gun with a hot 
nozzle can cause serious burns and/or ignite combustible 
objects.

To help prevent drips and clogs the next time the glue gun is 
used, remove dried glue from the nozzle area.

MAINTENANCE

NOTE: 

For better control and consistency of application, 

it is advisable to use two fingers to pull the trigger.



  When the desired amount of glue has been applied, re-

lease the trigger. Tilt the nozzle slightly to the side and 
carefully pull the nozzle away from the object. This helps 
avoid strings of glue clinging to the work.

NOTE: 

The glue gun will stop dispensing glue when the glue 

stick in the chamber is almost used up. To refill the chamber, 
set the glue gun down and insert another glue stick.



  Always turn the on/off switch to the off position when you 

are finished using the glue gun. Lift the drip tray located 
underneath the glue gun to catch any glue drips while the 
glue gun is cooling.



  Allow the glue stick and glue gun nozzle to completely 

cool before removing the battery pack.

OPERATION