For safety reasons, we recommend that the blades be
replaced by an authorized specialist
NOTE !
Wear work gloves!
To change the knife, proceed as follows:
NOTE !
If the blade is hard to pull out, use the appropriate tool like
pliers or screwdriver.
NOTE !
When installing a new knife, pay attention to the direction of
installation of the knife.
1. Press the retaining pin (Fig 8 / Pos. A), pull out the blade
as arrow indication direction, release the retaining pin.
2. Preess the retaining pin (Fig 9 / Pos. A) , insert the
blade as arrow indication direction, make sure the blade
in place, the release the retaining pin.
7
4. Inspect the condition of the cutting blade - note: wear
strong gloves when working with or around the cutting
blade.
5. Ensure that the cutting blade is not bent or cracked.
6. Check the condition of the blade and it’s mountings.
7. Check that the fixing bolt is secure.
8. Check the power supply cable
9. Inspect the ‘Switch control & safety button’.
10. Check that all securing nuts and bolts are tight.
WARNING!
If signs of damage are found, the mower unit
should not be used until fully repaired by a qualified person.
1. Remove all grass debris from the top and underside of
the mower deck, as well as from around the ventilation
holes, immediately after use - note: wear strong gloves
when working with or around the cutting blade.
2. Motor unit - this motor unit is maintenance free and
should not be accessed by anyone other than an
approved maintenance engineer.
3. Switch control & safety button - is maintenance free and
should not be accessed by anyone other than a
approved maintenance engineer.
LUBRICATE THE WHEELS, PIVOT POINTS AND
LINKAGES AFTER 25 HOURS OF USE
1. The cutting blade has sharp edges, always wear strong
gloves to protect your hands when working with or
around the cutting blade.
2. Always work away from the cutting edges of the blade to
avoid the risk of injury.
3. Care should be taken when turning or lifting the mower
unit.
REPLACE THE CUTTING BLADE AFTER 50 HOURS
OF USE
GENERAL MAINTENANCE
CUTTING BLADE
4. It is recommended that the cutting blade is replaced
every two years or after 50 hours operation, which ever
occure the sooner.
5. Damaged or worn blades should by replaced
immediately.
DO NOT USE ANY POWER TOOLS IF THE CABLE IS
DAMAGED OR WORN.
STORAGE FOR LONGER PERIODS
BLADE REPLACEMENT (Fig. 8, 9)
NOTE!
To ensure your mower is maintained in good
working order, if the storage period exceeds one month it is
important that the following is adopted:
1. Clean all areas of the mower, ensure that the grass
collection box is empty and clean.
2. Lubricate the wheels, pivot points and linkages.
3. Cover all metal parts with oil to prevent corrosion.
4. Cover the mower with a protective sheet and store in a
dry area.
NOTE!
All electrical inspections and repairs should be
conducted by a qualified electrician.
POWER SUPPLY CABLE
Before use, the power supply cable should be inspected for
signs of damage or ageing.
Summary of Contents for RCM-750
