3
English
Figure 26
42. Wedge (not provided)
Figure 27
43. Vertical cut
44. lodge section
45. Horizontal cut
Figure 28
46. Kickback
Figure 29
42. Wedge (not provided)
Figure 30
47. log supported at one end
48. Finishing cut
49. load
50. 1st cut 1/3 diameter
51. log supported at both ends
Figure 31
52. Overbucking
Figure 32
53. underbucking
Figure 33
49. load
50. 1st cut 1/3 diameter
54. second cut
48. Finishing cut
Figure 34
55. Cut limbs one at a time and leave support limbs
under tree until log is cut
Figure 35
56. springpole
Figure 36
22. run position
Figure 38
10. Clutch cover
Figure 39
57. Chain drive links
58. Cutters
59. Chain rotation
Figure 40
60. Bar groove
Figure 41
61. adjusting pin
62. Chain tensioning pin hole
63. sprocket
10. Clutch cover
Figure 42
64. rotate clutch cover knob clockwise to secure
12. Clutch cover lock knob
11. Chain tensioning dial
Figure 44
11. Chain tensioning dial
65. loosen chain
66. tighten chain
Figure 46
67. raker (depth gauge) clearance
Figure 47
68. Inspect drive sprocket
Figure 48
69. Gullet
70. Heel
71. rivet hole
72. top plate
73. Cutting corner
74. side plate
75. Depth gauge
76. toe
Figure 51
77. left hand cutters
78. right hand cutters
Figure 52
79. top plate filing angle
80. Correct
81. less than 30 degree
82. more than 30 degree
83. Incorrect
Figure 53
80. Correct
84. side plate filing angle
85. Hook
86. Backward slope
Figure 54
67. raker (depth gauge) clearance
Figure 55
87. Depth gauge jointer
