34 — English
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
SOLUTION
Motor stops while cutting.
Cutting height set too low.
Battery charge is low.
Operator is not fully seated.
Raise the cutting height.
Charge the battery.
Sit down fully on the seat, return the
drive levers to the neutral position, and
push the blade engage knob down.
Then try again.
Blades do not rotate.
Battery charge is low.
Blade engage knob is down.
Operator is not fully seated.
Build-up of debris under mower deck.
Charge the battery.
Raise blade engage knob.
Sit down fully on the seat, return the
drive levers to the neutral position, and
push the blade engage knob down.
Then try again.
Clean underside of mower deck.
Blades do not rotate while moving in
reverse.
Blade engage knob is down.
Raise blade engage knob.
Mower won’t reach full speed.
Battery charge is low.
Low speed drive feature is engaged.
Charge the battery.
Turn off low speed drive.
Blades continue to turn after operator
leaves seat without parking brake set.
Safety interlock system is not func-
tioning correctly.
Ensure safety interlock system seat plug
is fully connected. If blades still won’t
stop, take mower to authorized service
center for repair.
Headlights not working.
Headlights are off.
Headlights are damaged.
Press headlight button to turn head-
lights on.
Have headlights replaced at an autho-
rized service center.
Battery will not charge.
Bad battery cells.
Poor cable connections.
Replace battery.
Check/clean all battery connections.
If problem persists after trying the above solutions, contact customer service or an authorized service center for assistance.
Summary of Contents for RY48ZTR100
Page 70: ...NOTES...
Page 107: ...NOTES NOTAS...
