1
ASSEMBLy
CONNECTING THE HIGH PRESSURE HOSE TO
THE PUMP
See Figure 9.
After the high pressure hose has been uncoiled and attached
to the spray wand:
Pull back and hold the quick-connect collar on the
pump.
Insert the
nozzle on the end of the quick-connect high
pressure hose into the collar.
Release the collar.
Pull on the hose to be certain it is properly secured.
CONNECTING THE GARDEN HOSE TO THE
PRESSURE wASHER
See Figure 10.
Water supply must come from a home water main. NEVER
use hot water or water from pools, lakes, etc. Before
connecting the garden hose to the pressure washer:
Run water through the hose for 30 seconds to clean any
debris from the hose.
Inspect the screen in the water intake.
If the screen is damaged, do not use the machine until
the screen has been replaced.
If the screen is dirty, clean it before connecting the garden
hose to the machine.
To connect the garden hose to the machine:
Uncoil the garden hose.
NOTE: There must be a minimum of 10 feet of
unrestricted hose between the pressure washer intake and
the hose faucet or shut off valve (such as a “Y” shut off
connector).
With the hose faucet turned completely off, attach the
end of the garden hose to the water intake. Tighten by
hand.
OPERATION
wARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this tool. The use of
attachments or accessories not recommended can result
in serious personal injury.
wARNING:
Do not direct discharge stream at persons. Failure to heed
this warning could result in serious injury.
wARNING:
Do not allow familiarity with tools to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
wARNING:
Always wear safety goggles or safety glasses with side
shields when operating tools. Failure to do so could
result in objects being thrown into your eyes, resulting in
possible serious injury.
Fig. 10
Fig. 9
gArDen
HOse
HIgH PressUre
HOse
qUICK-COnneCt
COllAr
sCreen
Summary of Contents for RY80030A
Page 20: ...20 NOTES...
