Ryobi RY903622, Operator'S Manual

Page 10  — English

KNOW YOUR GENERATOR

See Figure 1.

The safe use of this product requires an understanding of the 
information on the product and in this operator’s manual as 
well as a knowledge of the project you are attempting. Before 
use of this product, familiarize yourself with all  operating 
features and safety rules.

AC CIRCUIT BREAKERS

The circuit breakers are provided to protect the generator 
against electrical overload. The circuit breaker may be reset 
by pressing the circuit breaker reset button.

AIR FILTER

The air filter helps to limit the amount of dirt and dust drawn 
into the unit during operation.  

ANSI/UL-2201 CERTIFIED

This generator complies with the ANSI/UL-2201 Standard 
for Low Carbon Monoxide (CO) Emission Rates for portable 
generators.  When used properly, portable generators with 
lowered CO emissions and CO shutoff capability mitigate 
the risk of CO related poisoning.

 DANGER:

ANSI/UL 2201 compliance is not a substitute for safe 
generator practices. Always operate the generator in 
open, outdoor areas, at least 20 feet away from occu-
pied structures. Never operate the generator near open 
windows, doors, or other unventilated spaces.

AUTOMATIC SHUTOFF

The generator’s carbon monoxide sensor is designed to 
monitor the level of carbon monoxide present during genera-
tor operation. If the unit is positioned incorrectly and carbon 
monoxide levels rise to an unsafe level, the LED on the sensor 
will flash red and the generator will automatically shut down. 
Leave the area immediately and relocate to an open outdoor 
area. Ventilate the area thoroughly before occupying again. 
Ensure the generator is located in an open, outdoor area at 
least 20 feet away from all doors, windows, and occupied 
spaces, and point exhaust away from occupied structures 
before restarting.

NOTE: 

After a shutoff event has occured, the LED will con-

tinue to flash red for up to 20 minutes. Once the generator 
is relocated and CO levels are safe, the generator can be 
restarted even if the light is still flashing.

ENGINE SWITCH/FUEL VALVE/ 
CHOKE LEVER

The engine switch/fuel valve/choke lever is used when start-
ing, stopping, and running the engine.

FUEL TANK

The fuel tank has a capacity of 4 gallons.

GROUND TERMINAL

The ground terminal is used to assist in properly grounding 
the generator to help protect against electrical shock. Consult 
with a qualified local electrician for grounding requirements 
in your area.

LOW OIL SHUT DOWN PROTECTOR

The low oil sensor causes the engine to stop if the level of 
lubricant in the crankcase is insufficient. 

OIL CAP/DIPSTICK

Remove the oil fill cap to check and add lubricant to the 
generator when necessary.

OIL DRAIN PLUG

When changing the engine lubricant, unscrew and remove 
the oil drain plug to allow old engine lubricant to be drained.

RECEPTACLES

Your generator has the following single phase, 60 Hz out-
lets: two 120 Volt AC, 20 Amp duplex receptacles  and one 
120 Volt AC 30 Amp RV receptacle. These can be used for 
operating appropriate appliances, electrical lighting, tools, 
and motor loads.

RECOIL STARTER GRIP

The recoil starter grip is used to start the generator’s engine.

FEATURES

PRODUCT SPECIFICATIONS

ENGINE

Engine Type ...................................................... 212cc OHV
Spark Plug .................................NGK BP6ES or equivalent 
Engine Lubricant Volume................... approximately 20 oz.
Fuel Volume ................................................................4 gal.

GENERATOR

Rated Voltage .............................................................120 V
Rated Amps ................................................................. 30 A
Rated Output*......................................................... 3600 W
Starting Watts ......................................................... 4500 W
Rated Frequency ....................................................... 60 Hz

*Rated output determined by PGMA Standard G300