Page 9 — English
GENERATOR CAPACITY
Make sure the generator can supply enough continuous (run-
ning) and surge (starting) watts for the items you will power
at the same time. Follow these simple steps.
1. Select the items you will power at the same time.
2. Total the continuous (running) watts of these items. This
is the amount of power the generator must produce to
keep the items running. See the wattage reference chart
at right.
3. Estimate how many surge (starting) watts you will need.
Surge wattage is the short burst of power needed to
start electric motor-driven tools or appliances such as a
circular saw or refrigerator. Because not all motors start
at the same time, total surge watts can be estimated by
adding only the item(s) with the highest additional surge
watts to the total rated watts from step 2.
Example:
Tool or Appliance
Running
Watts*
Starting
Watts*
Window AC,
10,000 BTU
1200
1800
Refrigerator
700
2200
1/3 HP Well Pump
1000
2000
27 in. Television
500
0
Light (75 Watts)
75
0
3475 Total
Running Watts
2200 Highest
Starting Watts
Total Running Watts
3475
Highest Starting Watts + 2200
Total Starting Watts Needed
5675
POWER MANAGEMENT
To prolong the life of the generator and attached devices,
it is important to take care when adding electrical loads to
the generator. There should be nothing connected to the
generator outlets before starting its engine. The correct and
safe way to manage generator power is to sequentially add
loads as follows:
1. With nothing connected to the generator, start the engine
as described later in this manual.
2. Plug in and turn on the first load, preferably the largest
load you have.
3. Permit the generator output to stabilize (engine runs
smoothly and attached device operates properly).
4. Plug in and turn on the next load.
5. Again, permit the generator to stabilize.
6. Repeat steps 4 and 5 for each additional load.
Never add more loads than the generator capacity. Take
special care to consider surge loads in generator capacity
as previously described.
Application/Equipment
Estimated
Running
Watts*
Estimated
Starting
Watts*
Emergency / Home Standby
Clock Radio
50
0
Lights (qty. 4 x 75 W)
300
0
Refrigerator
700
2200
Furnace Fan
800
2350
Water Well Pump
1000
1500
Microwave
1000
1000
Sump Pump
1050
2200
Electric Range (per element)
2100
0
Job Site
Electric Drill − 1/2 HP
600
900
Airless Sprayer − 1/3 HP
600
1200
Quartz Halogen Work Light
1000
1000
Reciprocating Saw
960
1920
Air Compressor − 1 HP
1600
4500
Circular Saw − 7-1/4 in.
1400
2300
Planer/Jointer − 6 in
1800
1800
Miter Saw − 10 in.
1800
1800
Table Saw/Radial Arm Saw − 10 in.
2000
2000
*Wattages listed are approximate. Check tool or appliance for actual wattage.
NOTICE
:
Do not overload the generator’s capacity. Exceeding the
generator’s wattage/amperage capacity may damage
the generator and/or electrical devices connected to it.
ELECTRICAL
Summary of Contents for RY906500
Page 62: ...NOTES NOTAS...
Page 63: ...NOTES NOTAS...
