Ryobi RY906500 Operator'S Manual Download

Page: 16 / 64

Page 12 — English

INSTALLING THE WHEELS

See Figure 6.

Wheels are provided to assist in moving the generator to
the desired location and should be installed on the same
side as the handle.



Locate the following items:

  2 axles
  2 hitch pins
  2 washers
  2 wheels

DANGER:

Carbon Monoxide.

Using a generator indoors CAN KILL

YOU IN MINUTES.
Generator exhaust contains high levels of carbon mon-
oxide (CO), a poisonous gas you cannot see or smell. If
you can smell the generator exhaust, you are breathing
CO. But even if you cannot smell the exhaust, you could
be breathing CO.



Never use a generator inside homes, garages, crawl-
spaces, or other partly enclosed areas. Deadly levels
of carbon monoxide can build up in these areas. Us-
ing a fan or opening windows and doors does NOT
supply enough fresh air.



ONLY use a generator outdoors and far away from
open windows, doors, and vents. These openings
can pull in generator exhaust.

Even when you use a generator correctly, CO may
leak into the home. ALWAYS use a battery-powered or
battery-backup CO alarm in the home.
If you start to feel sick, dizzy, or weak after the generator
has been running, move to fresh air RIGHT AWAY. See
a doctor. You could have carbon monoxide poisoning.

WARNING:

If this generator will be used

only

with cord and plug-

connected equipment, National Electric Code does
not require that the unit be grounded. However, other
methods of using the generator may require grounding
to reduce the risk of shock or electrocution. Consult a
qualified electrician, electrical inspector, or local agency
having jurisdiction for local codes or ordinances to find
out if grounding is needed in your situation before using
the generator.

ASSEMBLY



Raise the end of the generator where the handle is located
high enough to gain access to the frame bottom; securely
position props underneath to support.



Slide the axle through the hole in the center of the wheel.



Slide a washer onto the axle, then slide the axle into the
wheel mounting hole as shown.



Insert hitch pin to secure.

NOTE:

The hitch pin should be pushed into the axle until

the center of the pin rests on top of the axle.



Repeat with the second wheel.

OPERATION

WARNING

Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.

WARNING

Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.

NOTICE:

This product is equipped with a spark arrestor that has
been evaluated by the USDA Forest Service; however,
product users must comply with Federal, State, and local
fire prevention regulations. Check with appropriate au-
thorities. Contact customer service or a qualified service
center to purchase a replacement spark arrestor.

NOTICE:

Before each use, inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts,
caps, etc. Tighten securely all fasteners and caps and
do not operate this product until all missing or damaged
parts are replaced. Please contact customer service or
a qualified service center for assistance.

APPLICATIONS

This generator is designed to supply electrical power for
operating compatible electrical lighting, appliances, tools,
and motor loads.