Ryobi RYI1000 Operator'S Manual Download

Page: 19 / 68

15 — English

OPERATION

MAINTENANCE

GENERAL MAINTENANCE

Keep the generator in a clean and dry environment where it
is not exposed to dust, dirt, moisture, or corrosive vapors.
Do not allow the cooling air slots in the generator to become
clogged with foreign material such as leaves, etc.
Do not use a garden hose to clean the generator. Water
entering the fuel system or other internal parts of the unit can
cause problems that will decrease the life of the generator.

To clean the unit:



Use a soft bristle brush and/or vacuum cleaner to loosen

and remove dirt and debris.



Clean air vents with low pressure air that does not exceed

25 psi.



Wipe the exterior surfaces of the generator with a damp cloth.

CHECKING/CLEANING AIR FILTER

See Figure 13.

For proper performance and long life, keep air filter clean.



Loosen the screw at the top of the engine maintenance

cover. Remove cover and set aside.



Depress tabs on top and bottom of air filter cover. Remove

cover and set aside.



Remove the air filter.



Wash the air filter with warm, soapy water. Rinse and

squeeze to dry.



Reinstall the air filter.

NOTE:

Make sure the filter is seated properly inside the

generator. Installing the filter incorrectly will allow dirt to
enter the engine, causing rapid engine wear.



Reinstall the air filter cover by aligniing the tabs on the

cover with the slots in the generator housing.

Normal maintenance, replacement or repair of emission
control devices and systems may be performed by any
qualified repair establishment or individual with original
or equivalent parts. Warranty and recall repairs must be
performed by an authorized service center; please contact
customer service for assistance.

WARNING:

Before inspecting, cleaning, or servicing the machine,
shut off engine, wait for all moving parts to stop, and
disconnect spark plug wire and move it away from
spark plug. Allow 30 minutes of cool down time before
performing any maintenance. Failure to follow these
instructions can result in serious personal injury or
property damage.

WARNING:

When servicing, use only recommended or equivalent
replacement parts. Use of any other parts could create
a hazard or cause product damage.

NOTICE:

Periodically inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts,
caps, etc. Tighten securely all fasteners and caps and
do not operate this product until all missing or damaged
parts are replaced. Please contact customer service or
a qualified service center for assistance.

sparks, damage to the battery or generator, or even burns
or explosions.

NOTE:

To prevent short circuit, keep away from a metal

surface during clamp connection.



Connect the battery charging cable assembly to the

12 V DC receptacle.



Start the generator.

NOTE:

The AC receptacles can be used while the DC

receptacle is in use.



The battery will become slightly warm to the touch while

charging. This is normal and does not indicate a problem.

NOTE:

Only use battery charging cable assembly to

charge vented wet lead acid batteries.



When batteries become fully charged, disconnect

the battery charging cable assembly from the battery.
Disconnect the negative (black) wire first, then the positive
(red) wire, being careful not to short across the terminals.

Always abide by the safety warnings provided with the
battery.

NOTE:

Most batteries will be completely charged after

30 to 120 minutes. However, it is highly recommended
that you refer to your battery manufacturer’s instructions
for specific charge times.



Unplug battery charging cable assembly and store for

later use.

HIGH ALTITUDE OPERATION

Your engine is configured for operation below 1500 feet

altitude at the factory. Your engine must be reconfigured for

operation above 1500 feet altitude. Operating the engine

with the wrong engine configuration at a given altitude may