Ryobi RYi1802B6, Operator'S Manual

8 — English

FEATURES

KNOW YOUR PRODUCT

See Figure 1.

The safe use of this product requires an understanding of the 
information on the product and in this operator’s manual as 
well as a knowledge of the project you are attempting. Before 
use of this product, familiarize yourself with all  operating 
features and safety rules.

120 V AC RECEPTACLES

Your product has three single phase, 60 Hz outlets that  are 
120 Volt AC, 15 Amp receptacles. These can be used for 
operating appropriate appliances, electrical lighting, tools, 
and motor loads.

AC OUTPUT BUTTON

The AC output button is used to activate the 120V AC outlets 
when the power station is on. If an overload occurs, remove 
all loads, then press the AC output button again to reset. 

CARRY HANDLE

The product is equipped with a carry handle for easy trans-
port. The handle should be used to carry the product.

CHARGER

Using the charger before storing the power station helps 
keep the power station’s battery charged and ready at all 
times.

GENCONTROL

™

 WITH BLUETOOTH

®

The GENCONTROL

™

 monitoring system with 

Bluetooth

®

tracks battery level, runtime, load, and other functions.

LED TASK LIGHT

The LED task light can be used to provide general illumina-
tion for most work spaces.

MAIN POWER BUTTON

The main power button is used to turn the power station 
on and off. When turned on, power is available at the USB 
ports and to the LCD screen and LED task light. To use the 
AC outlets, the AC output button must also be turned on.

PARALLEL KIT TERMINALS

The non-polarized parallel kit terminals are used with a 
parallel kit that will allow products to be linked together to 
increase output. 

NOTICE:

Connect the cables before turning the product on. Do 
not disconnect cables while the product is running. The 
product or the load may be damaged.

NOTE:

 Read and understand the parallel kit’s instructions 

prior to use. Battery-powered inverters will not have a ground 
terminal; the ground wire will not be needed and can be left 
unconnected.

PROTECTIVE COVER

The protective cover can be used during use or storage for 
keeping dust, grease, and paint spatters off the unit. The 
convenient pocket provides storage for the charger.

USB PORTS

This product has four USB-A (5V, 2.1A) and two USB-C 
(5/12/20V, 3A) charging ports that will charge most USB-
compatible devices.

PRODUCT SPECIFICATIONS

Power Source ..................................................... 40 Volt DC
Rated AC Output ...............120 Volt AC, 60 Hz., 13.3 Amps

(15.0 Amps for 3 min. Max)

Rated DC Output:
 USB-A ...................................... 5 Volts, up to 2.1 Amps
 USB-C ...............................5/12/20 Volts, up to 3 Amps

Rated Output ..................1,600 W (1,800 W for 3 min. Max)
Starting Watts ......................................................... 3,000 W
Charger Input...............(nominal) 120V/60Hz AC only, 80 W
Charging Time ......... Dependent on quantity and amp hour 

capacity of battery pack(s)

Operating Temp. ..................................................32°–104°F