28
ADJUSTMENTS
DANGER:
Laser radiation. Avoid direct eye contact with light source.
WARNING:
Use of controls or adjustments or performance of pro-
cedures other than those specified herein may result in
hazardous radiation exposure.
TO ADJUST THE LASER GUIDE
See Figure 37.
Use the work clamp or a C-clamp to secure a piece of
scrap wood.
Plug the saw into the power source and make a slight
cut to score the wood.
Release the switch trigger and allow the saw blade to
stop rotating before raising the blade.
Raise the saw arm.
Unplug the saw.
To adjust the laser, loosen the laser adjustment screw
using the Phillips end of the supplied blade wrench.
NOTE: When properly aligned, the laser should be on the
left edge of the kerf.
Once aligned, tighten the screw then remove the blade
wrench.
LASER
ADJUSTMENT
SCREW
Fig. 37