INSTALLING THE DRIVE LEVERS
See fig. 4.
1. Remove the hex head bolts, lock
washers, and flat washers from the drive
lever mounting brackets.
2. Align the holes in the drive lever with the
holes on the mounting bracket.
3. Reinstall and securely tighten the washers
and bolts.
NOTE:
Make sure to use the same holes for
mounting the drive levers on each side. The
drive levers must be even once installed.
Fig 4
Drive lever
Bolts
Washers
Washers
INSTALLING THE HITCH PLATE
See fig. 5.
1. Align the holes in the towing plate with the
holes in the rear crossmember.
2. Install and securely tighten washers and
bolts.
Fig. 5
Bolts
Hitch plate
CHARGING THE PRODUCT
See fig. 7 - 8.
Mower batteries must be charged for 24 h
before
fi
rst use. To verify that the mower
batteries are fully charged, check the battery
level indicator.
For best results:
■
Do not charge in an area of extreme
heat or cold. The batteries charge best at
temperatures from 0 °C to 40 °C.
■
Never charge a frozen battery.
■
Mount or place the charger in an area with
adequate ventilation, without covering the
cooling fins.
■
Make sure that both the charger and
mower connections are clean and free of
dirt or debris.
To charge:
1. Insert the charger plug into the charging
port on the mower, making sure that it is
properly connected.
2. Connect the charger to a power supply
using normal household current of 220-
240 V ac, 50 / 60 Hz. The batteries should
automatically begin to charge.
3. When you are ready to mow, disconnect
the charger from the power supply, then
disconnect the charger from the mower.
5
English
|
EN
FR
DE
DA
SV
FI
NO
Summary of Contents for ZTR480ex
