Ryobishi RB-07HP, Operating Instructions Manual

Note:

●

 When power is connected

(stand by condition), you can operate the air conditioner 

   through the remote controller.

● 

When unit is on, each time you press the button on remote controller, the sending 

   signal icon "     " on the display of remote controller will blink once. If the air con-
   ditioner gives out a beep sound, it means the signal has been sent.  

● When unit is o

ff, set temperature will be displayed on the remote controller (If the 

   light of indoor unit display is turned on, the corresponding icon will be displayed); 
   When unit is on, it will display the icon of the on-going function. 

Press this button to turn unit on/off.

ON/OFF button

1

Pressing this button once can select your required mode circularly as below (the 
corresponding icon "    " will be lit up after the mode is selected):

● 

When selecting auto mode, air conditioner will operate automatically according to

    ambient temperature. Set temperature can't be adjusted and won't be displayed
    either. Press FAN button to adjust fan speed.

● When selecting cool mode, air conditioner will operate under 

cool mode. Then 

   press + or - button to adjust set temperature. Press FAN button to adjust fan speed.

● When selecting dry mode, air conditioner will operate at low 

fan speed under dry 

   mode. In dry mode, fan speed can't be adjusted.

● When selecting fan mode, air conditioner will operate in fan 

mode only. Then 

   press FAN button to adjust fan speed.

● When selecting heat mode, air conditioner will operate under 

heat mode. Then 

   press + or - button to adjust set temperature. Press FAN button to adjust fan speed. 
   (Cooling only unit can’t receive heating mode signal. If set HEAT mode by remote 
   controller, press ON/OFF button can’t turn on the air conditioner.)

AUTO

COOL

DRY

FAN

HEAT

MODE button

2

● 

Pr or - button once will increase or decrease set temperature by 1°F(°C). 

   Hold + or - button for 2s, set temperature on remote controller will change quickly. 
   Release the button after your required set temperature is reached.

● When setting

 Timer On or Timer Off, press + or - button to adjust the time.

(See 

   TIMER Button for setting details)

+ / - button

3

● This is a general use remote controller, it could be used for

 the air conditioners

with multifunction; For some function, which the model doesn't have, if press
the corresponding button on the remote controller that the unit will keep the
original running status.

- 1

1

 -

Introduction for buttons on remote controller