10
www.sc-black.com
SECTION 2: INSTALLATION AND SETUP
2.6 Install the encoder
1. Determine where the encoder will be mounted and record the Media Access Control (MAC) address
of the encoder. The MAC address can be found on a label on the underside of the encoder. Record
the information in the following table.
Location:
MAC address:
2. Slide the mounting brackets provided in the hardware kit into the slots on the side of the encoder.
3. Do one of the following:
—
If the mounting surface is a hard material, use the 1/2” self-tapping mounting screws
provided in the hardware kit to secure the encoder to the surface.
—
If the mounting surface is a soft material:
i.
Using the encoder with the mounting brackets as a template, mark the location of the
mounting screw holes.
ii. Drill 1/4” holes in the location of the mounting screw holes for the wall inserts provided
in the hardware kit.
iii. Tap the wall inserts into the holes until they are flush with the surface.
iv. Use the 1-1/8” screws provided in the hardware kit to secure the encoder to the surface.
4. Connect an analog signal source (camera video) to the Vin BNC connector on the front of the
encoder.
2.7 Connections
Connections to the encoder for audio in and out (microphone and speaker), D/I sensor, alarm, video out
BNC, RS-232C, and RS-485 control are made through two 9-pin terminal blocks. The two 9-pin terminal
block may be detached from the encoder. Install the two blocks into the connectors on the back of the
encoder.
