6K V1.02 03-16-91
84
AUTOPATCH
REDIAL LAST NUMBER
Command Form:
(PW) 84 *
Description:
This command allows you to redial the last number dialed by the
autopatch without entering the entire access code and phone number
again. This feature is particularly useful if the number you called was
busy or not answered. The command works up to 30 minutes from the
time the last call was placed. If more than 30 minutes have elapsed, the
controller will send CLR (dialer cleared) in CW. The 30-minute timer will
be reset after each redial attempt.
It is recommended that users not use the Redial Last Number command if
they have not been monitoring the repeater for a while, since another call
may have been placed since their call.
The dialer memory is cleared during a warm or cold start; when the
autopatch Call Type command is used; after a 30-minute timeout; and when
the Clear Redialer command is entered.
Macros created for autopatch
“speed dialing” also leave a number in the
dialer memory. Therefore, entering a Redial Last Number command
following one of these macros will result in a call to the speed dialed party.
An attempt to access the autopatch that is not successful, such as dialing a
long-distance number that is rejected, will not clear the redialer or affect the
redialer timer.
Acknowledgement:
none
Errors:
? ERR 1
wrong number of digits entered
CLR
dialer memory is empty (cleared)
Default Condition:
the dialer memory is cleared
