9
4 Installation
4.2 Pressure gauge
Without removing the pressure gauge from its
position, gently pierce a small hole in the rubber
cap on the top. (Fig. 8 & 9).
Figure 8
Figure 9
4.3 Tank installation
1. On the right hand side of the Solo Resce
®
,
loosen the nuts on the levelling feet and
position the tank. Fixate it by tightening the nuts
again (Fig. 10).
2. Make sure the tank is in level by adjusting its
feet (Fig. 11).
Continues on next page –>
Figure 10
Figure 11
