SE-RDA User Instructions 100507-03 B
Copyright © 2021 The S.E.A. Group
13
3.
Ensure that the vent port filter is open to the air and not covered by clothing.
4.
Don the respirator as per the respirator user instructions.
5.
Position the pressure tube close to the body to minimise snagging hazard. The
tube may be tucked inside clothing. Ensure that the tube is free of kinks.
Mounting SE-RDA unit
Pocket mounted
Waist-belt mounted
Download the data
Downloading the data is described in the paragraph “To download data from the SE-RDA
unit to the PC” on page 23 of this document.
Turn the SE-RDA OFF
Press and hold RECORD and FUNCTION buttons simultaneously. Hold buttons for about 3
seconds until the LED goes out. Release buttons. Make sure LED is out.
Decontamination and cleaning
After working in a contaminated environment, the SE-RDA unit, adapter and respirator
may require decontamination to prevent contamination of clean areas and prevent
contamination of and/or injury to the user and other personnel.
Decontamination procedures should be developed as part of the organisation’s respirator
program and should be appropriate to the hazards involved.
When decontaminating, consider the following:
•
The SE-RDA is water-resistant. It is NOT waterproof. Never submerge the unit in
water.
•
Do not remove the respirator from the face nor disconnect the SR100/200
adapter from the unit during decontamination.
•
After removing the respirator, do not allow direct water streams inside the
facepiece. Water may enter the opening of the pressure tube and affect
measurement accuracy.
•
The vent port filter should always be replaced after decontamination in a shower.
•
During decontamination, water may collect under the lip of the battery cover.
When removing the battery cover after decontamination, take care to wipe away
excess water and prevent it from entering the battery chamber.
