S.E.M. Z-255-BTPFU5W User Manual Download

Page: 4 / 6

MINS

OFF*

MINS

- THIS SET HAS A SPECIAL SLEEP TIMER FUNCTION WHICH CAN AUTOMATICALLY
SWITCH OFF THE UNIT. THIS IS USEFUL FOR SLEEPING TO MUSIC.
- AT ANY TIME WHILE THE UNIT IS OPERATING, PRESS AND HOLD THE

SLEEP

KEY

FOR 3 SECONDS REPEATEDLY TO CHOOSE THE AUTOMATIC POWER OFF TIME.

(*OFF MEANS SLEEP TIMER IS DEACTIVATED)

AUTOMATIC POWER OFF SLEEP FUNCTION

HOW TO SET TIMER

- THIS SET HAS A ALARM FUNCTION TO ENABLE YOU T O PROGRAM THE UNIT
AS A WAKE-UP ALARM CLOCK :

  1. IN STANDBY MODE, PRESS  ALARM SET  KEY ONCE.
  2. PRESS         TUNE UP  OR         TUNE DOWN   TO ADJUST THE HOUR OF
      THE DESIRED "ON" TIME AND THEN PRESS  ALARM SET  KEY TO CONFIRM.
  3. PRESS         TUNE UP  OR         TUNE DOWN   TO ADJUST THE MINUTES OF
      THE DESIRED "ON" TIME AND THEN PRESS  ALARM SET  TO CONFIRM.
  4. NOW THE WORDING IN THE DISPLAY CHANGES TO SHOW "     " (BUZZER ALARM).
  5. PRESS   ALARM SET  KEY TO CONFIRM.
6. FINALLY THE UNIT WILL RETURN TO THE NORMAL DISPLAY, EXCEPT THAT THE
         SYMBOL WILL BE SHOWN, TO INDICATE THAT YOU  HAVE PROGRAMMED A ON/OFF
     ALARM SETTING.
7. IN CASE YOU  WISH TO DISABLE THE TIMER, LONG PRESS THE  ALARM SET  KEY
     FOR  3 SECONDS, & THE      SYMBOL WILL DISAPPEARS.

ALARM FUNCTION

SNOOZE FUNCTION

- WHENEVER THE ALARM COMES ON, IT CAN BE TEMPORARILY SUSPENDED
  FOR A SHORT PERIOD OF APPROXIMATELY 9 MINUTES, BY PRESSING
  THE “SNOOZE” KEY ONCE, "SNOOZE" WILL LIT ON DISPLAY.
- THE ALARM WILL THEN AUTOMATICALLY COME ON AGAIN AFTER APPROXIMATELY
  9 MINUTES “SNOOZE” PERIOD HAS ENDED.
- THE PROCEDURE CAN BE REPEATED FOR APPROXIMATELY AN HOUR.

E-7

E-8

ELECTRONI C VOLUME CONT ROL

- THIS UNIT USES AN ELECTRONIC VOLUME CONTROL

- TO INCREASE OR  DECREASE THE LOUDNESS OF  UNIT, PRESS
  THE VOLUME  UP (+) OR  VOLUME  DOWN (-) KEYS RESPECTIVELY.
- RELEASE THE KEY WHEN VOLUME  LEVEL IS AT THE DESIRED LOUDNESS.
- SOMETIMES, ESPECIALLY DURING LISTENING TO THE RADIO, YOU  MAY NOTICE
  A "CLICK-CLICK-CLICK" (REPEATING)  SOUND WHEN YOU ARE INCREASING OR
  DECREASING THE VOLUME. THIS IS A NORMAL CONDITION  & THE SOUND WILL
  DISAPPEAR WHEN YOU  RELEASE THE VOLUME  KEY (WHEN YOU  REACH THE
  DESIRED VOLUME  LEVEL).

(PUSH BUTTON TYPE)

OPER ATION OF RADI O

- PRESS THE "ON/STANDBY" KEY ONCE TO SWITCH ON THE UNIT.
- PRESS THE                           KEY REPEATEDLY UNTIL THE DISPLAY SHOWS THE RADIO
  FREQUENCY.
- TO IMPROVE FM-RADIO RECEPTION, FULLY EXTEND THE FM-ANTENNA WIRE
  AND ADJUST IT'S POSITION.
- USE THE  FM MODE  KEY TO SELECT THE DESIRED MODE (FM MONO/STEREO).
  IN SOME CASES, WHERE RECEPTION  IS POOR, IT MAY BE ADVISABLE TO SELECT
  "MONO"  MODE, TO IMPROVE CLARITY OF THE RADIO SIGNAL.

MANUAL FREQUENCY ADJUSTMENT (SCAN MODE)

- PRESS (AND IMMEDIATELY RELEASE) THE
  KEYS TO "SCAN" (MANUALLY ADJUST) THE RADIO FREQUENCY "UP" OR "DOWN"
  BY 1-STEP AT A TIME.
- THE RADIO DIGITAL DISPLAY WILL INDICATE THE EXACT FREQUENCY AT EACH
  STEP’S POSITION.
- WHEN A DESIRED FREQUENCY OR  STATION  IS REACHED. IT CAN BE SAVED
  INTO ONE OF THE "MEMORY" POSITIONS. (SEE "RADIO MEMORY" SECTION).

TUNE UP OR TUNE DOWN

AUTOMATIC FREQUENCY ADJUSTMENT (SEEK MODE)

- PRESS AND HOLD (FOR  2 SECONDS) THE
  KEYS TO "SEEK" (AUTOMATICALLY ADJUST) THE RADIO FREQUENCY "UP" OR
  "DOWN" TO THE NEXT AVAILABLE RADIO STATION.
- THE RADIO DIGITAL DISPLAY WILL INDICATE THE EXACT FREQUENCY OF THE
  NEXT STATION THAT IS FOUND.
- WHEN A DESIRED STATION  IS REACHED. IT CAN BE SAVED INTO ONE OF THE
  "MEMORY" POSITIONS. (SEE "RADIO MEMORY" SECTION).

TUNE UP OR TUNE DOWN

FUNCTION

RADIO MEMORY (STATION P RESET MEMORY STORAGE)

- AT ANY TIME, THE CURRENTLY DISPLAYED STATION  OR  FREQUENCY CAN BE
  STORED INTO ONE OF THE MEMORY POSITION.
- PRESS

KEY ONCE, THE MEMORY POSITION WILL SHOWS ON DISPLAY.

- PRESS THE         TUNE UP  OR         TUNE DOWN  KEY TO SELECT THE DESIRED
  MEMORY POSITION TO SAVE THE RADIO STATION. (THERE ARE 30 MEMORY
  POSITIONS "P01 TO P30).
- PRESS                          KEY

ONCE TO SAVE THE SELECTED STATION INTO THE

  SELECTED MEMORY POSITION.
- REPEAT THE ABOVE STEPS FOR  PROGRAMING THE MEMORY STATIONS AS  DESIRED.
- TO RECALL A STATION  IN MEMORY, PRESS THE                       KEY REPEATEDLY
  TO REACH THE MEMORY POSITION AS DESIRED.
- TO CLEAR THE MEMORY OF AN Y POSITION, SIMPLY SAVE A NEW STATION TO
  THE SAME  MEMORY POSITION.

PROGRAM

FM MEM.

NOTE:
1. THE WAKE UP VOLUME LEVEL WILL GRADUALLY AND AUTOMATICALLY INCREASE
  FROM ZERO (0) TO LEVEL 17 WHEN THE WAKE UP ALARM IS ACTIVATED.
  THIS CAN NOT BE CHANGED.
2. WHEN THE ALARM COMES ON, CAN PRESS ANY KEY (EXCEPT "SNOOZE" KEY) TO
  TURN IT OFF.

PROGRAM