700-3000 6.21.2016
10
The battery pack has an LED indicator near the plug-in-port. It will glow Red when first plugged into the
transformer. If the LED remains Red this indicates the battery pack needs charging. When fully charged
the LED will glow Green. If the battery is fully charged and is plugged into the transformer the LED will
glow Red for approximately 10 sec. then glow Green. If the LED flashes Red when plugged in this
indicates a fault with the battery and indicates the battery pack should be replaced. All batteries are
inspected prior to shipment. See warranty policy regarding battery replacement for problems after sale.
Batteries have a normal lifespan of between 2-3 years, depending on use and care. A fully charged
battery will provide approximately 30 to 40-lifting cycles, depending on the weight of the users. Prior to
use the battery charge level should be checked by observing the LED indicator above the charger plug to
ensure sufficient charge level. The charger must be connected to the battery to view the LED.
It is not necessary to fully discharge the battery prior to charging. Battery should be charged daily and
cannot be overcharged. It takes up to twelve hours to fully charge depending upon battery usage. Do not
allow battery to fully discharge, as it will shorten battery life.
Do not drop the battery, as it could cause the unit to fail. If the battery case is cracked do not use and
replace the battery. During temperature extremes beyond the range of 41 F (5 C) to 104 F (40 C) remove
battery and place in a controlled environment or battery life may be shortened.
Battery Disposal
- The batteries located inside the battery pack are recyclable and shall be disposed of
in accordance with applicable local, state/provincial or federal/national regulations.
Locking Plate Assembly
- The battery pack can be secured to the mounting plate using the provided
lock plate assembly. To install open the lock plate so that the bottom tabs are moved close to one another
to allow the lock plate to be inserted into the slots on the mounting plate secured to the lift. Close the lock
plate assembly so that the tabs are captured by the slots. Insert a padlock (not provided) through the
holes on the lock plate assembly to secure it.
Hand Control -
The four button unit controls all lift movements. The arrows indicate direction of
movement. Control is fully waterproof and meets IP67 standards.
Seating System -
The seat is manufactured from roto-molded plastic with a stainless steel
frame.
The seat belt must be used during each use. The footrest is removable and will float upwards to
prevent damage if the seat is lowered too far. It is recommended that the seat be rinsed off with
fresh water between each use and cleansed daily with a disinfectant solution of 1:100 dilution of
household bleach to fresh water and then rinsed with fresh water. In the event of a
contamination incident such as patient/user excreta - cleanse seat and seatbelt immediately with the
above disinfectant solution. Do not use seat or seatbelt if it is damaged or becomes worn out.
The optional armrests (US only - standard on export models) are designed for support when transferring
onto the seat. They can be rotated up out of the way during transfer. If the lift did not include the optional
arm rests (US only) they can be purchased separately and easily installed at a later date.
