6
W I N T E R I Z AT I O N R E C O M M E N D AT I O N S
B A S I C O P E R AT I O N
Swimming Pools may or may not be drained completely. If not drained completely, the water level
should be lowered below the S.R.Smith
kēlo
LED Light and make sure that all water is drained
from the wall fitting and conduit. Alternatively, the S.R.Smith
kēlo
LED Light may be removed
completely, the conduit purged of all water, and a 1 1/2” NPT male plug with thread sealing tape
may be used to close the wall fitting.
NOTE
- If water is trapped in conduit, damage may occur from freeze expansion.
When connected to an approved, 12VAC, Class 2 power supply - The S.R.Smith
kēlo
LED color
changing light uses simple ‘off / on’ power switching to control the basic, pre-defined color modes
with memory function.
MEMORY
The memory function remembers the last color
setting. For example, if the light was last used in
the blue mode, the next time the light is turned on
it will be blue mode.
COLOR MODE SELECTION
The LED will turn on to the color in memory. To
move to the next color mode, quickly (within one
second or faster) toggle the power to the lights
’OFF / ON’.
Advance through the modes until the desired mode
is selected. The modes will cycle 1,2,3,4,5,6,7,8,
then cycle back to 1. See table below for details.
COLOR SYNC RESET
To synchronize all lights on the system including older *Fiberstars LED Series Pool lights, you
must use the following sequence:
1.
Turn lights ‘ON’ to confirm the color modes are out of sync.
2.
Turn lights ’OFF’ for 5 seconds or more.
3.
Toggles lights ’ON’ / OFF’ three times within three seconds - must end
in ’OFF’ condition
4.
Leave lights in ’OFF’ condition for 5 seconds.
5.
Turn lights ‘ON’ and confirm that all lights are in mode #1, Soft Color Change
* Older Fiberstars LED lights can synchronize with the newest generation lights ONLY if they have their DIP switches in their
default, ’All Down’ position. In a mixed environment, the Color Sync Reset will need to be performed each time the lights are
used and color synchronization is desired.
FOR LED COLOR CHANGING LAMP (RGB)
WHITE ONLY LAMPS ARE SIMPLY ON OR OFF
COLOR MODE SELECTION GUIDE
Mode 1
Soft Color Change
Mode 2
White
Mode 3
Blue
Mode 4
Green
Mode 5
Red
Mode 6
Amber
Mode 7
Magenta
Mode 8
Flash Color Change
Summary of Contents for kelo LED light
Page 2: ...2...
