700-9700
7.14.2022
29
Follow these guidelines to make sure that your anchor jig is installed properly:
1. Minimum concrete slab requirements for the multiLift2:
•
Slab
dimensions should be at least 42” X 60” X 4”, see Figure 23 above.
•
Anchors shall be installed at a
minimum of 4” or greater from the edge of the slab or expansion
joint.
•
Normal weight of concrete = 150 lbs/ft^3
•
Concrete minimum compressive strength at 28 days to be F’c =2500 psi.
•
Reinforcing bars shall conform to ASTM A615 Grade 60, deformed.
2. Use Figure 19 to determine the proper location to install the lift, making certain that the front anchors are
located the correct distance from the pool edge.
3. Assemble the deck anchors to the anchor jig as described in
Appendix B
4. on page 36.
5. Install the anchor jig and reinforcing rods per Figure 23.
6. Use the bonding lug provided on the anchor jig to attach the bonding wire per local codes. Contact your
local Authority having jurisdiction for the bonding requirements in your area.
7. Make sure that the top of the anchors are flush with the top surface of the slab.
8.
Allow concrete to cure per manufacturer’s instructions.
9. Once the concrete has cured, install the lift per the installation instructions.
USING THE multiLift2
Obey all User Instructions listed in the
Owner’s Manual whenever using lift. Obey all Caution, Warning,
Operating Instruction(s) and Labels located on the lift whenever using. It is the responsibility of the lift
Owner to ensure that the correct safety procedures have been put in place and a risk assessment carried
out.
If a User is mentally challenged or has physical disabilities these issues must be taken into account
to determine the number of persons required to complete the transfer onto the seat and the number of
persons required to be in the water, ready to receive the User. If the multiLift2 will be used by a disabled
person living on their own, a communication device should be installed in the area to call for assistance
in the event of an emergency. Only persons healthy enough for water activities should use the multiLift2.
Users should consult with their physician to determine if water activities are appropriate for the User.
Keep fingers and hands clear of lift arms during use.
multiLift2
Transferring Diagram
Figure
24
TOP VIEW
TOP VIEW
(EXTENDED)
(RETRACTED/DECK LOADING POSITION)
DECK TO WATER EDGE
