700-9700
7.14.2022
7
COMPONENT DESCRIPTION
The lift is made up of several main components:
multiLift2 Assembly-
Primary lift assembly includes frame components, mounting base, and actuator. All metal
lift components are manufactured from stainless steel or aluminum and powder-coated for additional corrosion
protection. The
multiLift2 can be assembled in either a right side or left side, field reversible, seat configuration.
Seat Assembly -
The seat is manufactured from roto-molded plastic with a stainless-steel frame. The seat
comes standard with a seatbelt. The seatbelt must be used during each use. It is recommended that the seat be
rinsed off with fresh water between each use and cleansed daily with a disinfectant solution of 1:100 dilution of
household bleach to fresh water and then rinsed with fresh water. In the event of a contamination incident such
as patient/user excreta - cleanse seat and seatbelt immediately with the above disinfectant solution. Do not use
seatbelt if it is damaged or becomes worn.
The armrests are designed for support when transferring onto the seat. They can be rotated up out of the way
during transfer.
The lift seat assembly is designed to be used exclusively with S.R.Smith aquatic access lifts.
Footrest-
The footrest is constructed of roto-molded plastic and is easily removable.
Control Box
- The LiftOperator unit controls all lift operations identical to the user handset.
Two cables connect to the bottom of the Control Box to enable operation of the lift. The
largest connector is for the hand control. Connector # 2 is for the actuator cable.
Touchpad Control
–
The touchpad control arrow keys can be used in the event the Hand Control is out of
reach or fails. Simply press and hold the arrow for the desired action for one
movement at a time
– Up, Down, Releasing the Arrow stops movement.
Battery Level LED Indicators
–
The Battery Level LED Indicators show battery charge levels. The LED’s will illuminate when either the
touchpad control or the Hand Control is activated and will stay lit for 10 seconds. At greater than 50% the
LED glows Green, at less than 50% the LED glows Amber, and less than 25% the LED glows Red and
indicates the battery requires charging. If the less than 25% LED glows Red, do not operate the lift.
Remove the battery and fully charge before use.
Service Required LED
–
The Service Required LED will illuminate when the battery pack has been removed/replaced 120 times -
approximately once every 4 months. This indicates that required maintenance for the lift must be
completed. Please see the Maintenance Section
of the Lift Owner’s Manual for the requirements. The
Service Required LED can be reset by inserting a standard FAT-formatted USB mass storage device
(not included) into the USB Port on the bottom of the controller
. When the service light is illuminated
the lift must not be used until required maintenance is performed.
CONNECTOR 2
(ACTUATOR
CABLE)
