S.R.Smith pLX-PL60, Installation Instructions And Owner'S Manual

9

TRANSFORMER

I n p u t   /   S u p p l y   L i n e   V o l t a g e

1.  Remove the metal input voltage isolation barrier by unscrewing the mounting screw. Once the 

securing screw is removed, the isolation cover will pull straight out to allow easier access to the 
conduit knockout locations. 

TRANSFORMER

  Metal Input Voltage Isolation 

Barrier Mounting Screw 

  Locations of Input  

Power Knockouts

Locations of Output  

Power Knockouts

*Note:

 Once all conduits are connected, replace the metal input voltage isolation barrier and 

mounting screw. Tighten until the mounting screw is secure.   

2.  Bring the supply power conduit to one of the four, lower right input power conduit knockout 

locations that terminate ‘inside’ the isolation barrier. No output connections are allowed 
through these knockout locations. 
 

*Note:

 The wiring of the input and output power are required to use separate conduits and 

must not share an individual conduit. No conduit should contain both input and output power 
wiring.

3.  Using a hole saw, open the knockouts for the size of the conduit (¾" or 1") being installed.

ON
OFF
REMOTE