8
F i n a l S t e p s
1.
Pull 12VAC cable into input power conduit and connect to
the appropriate power supply.
2. Pull in fiber optic cable from the water feature and insert port
tip into the black compression fitting - tighten until firmly
held in place. Do not overtighten as damage to the fiber optic
cable may result.
S.R.Smith, LLC
P.O. Box 400 | Canby, OR 97013
P
503.266.2231
TF
800.824.4387
srsmith.com
79-15278-00 REV6/18
Questions?
Contact One of Our Dedicated Lighting Specialists.
1-800-824-4387
x4012 or x2282
© 2018 S.R.Smith. All rights reserved.
3.
In some cases there may
be excess fiber optic
cable. DO NOT CUT
the cable, instead coil
the excess in as large of
a loop as possible and
place in the open area of
the enclosure. DO NOT
KINK. If more space is
required due to lots of
excess fiber, it may be
helpful to add a larger
pull box in between the
conduit and CLSFJB or
CLSFJB2 to house the
excess fiber.
4. Snap the fiber optic light source (CLS-2xx) into
the metal bracket and adjust the position until
both of the locating tabs on the ends of bracket
capture the top and bottom of the CLS-2xx
housing. Use cable tie (zip-tie) to close and
tighten the open ends of the mounting bracket.
WARRANTY INFORMATION
For Lighting product warranty information and details, please visit our website:
www.srsmith.com/warranty
FJB
FJB2
