35
5. Fasten the hardware through the holes on the front face of the Ladder angle bracket as shown in
Figure CC. The required h
ardware is as follows: 3/8” x 3-1/2” Button Head Cap Screw (10), 3/8” Flat
Washer (24), 3/8” Nylon Washer (23), 3/8” Flat Washer (24), 3/8” Lock Washer (25), 3/8” Hex Nut
(26).
6. Replace the hardware for the entrance guardrail brackets that was removed during the first step of
the ladder installation.
7. After these connections are completed, finish tightening the concrete anchor hardware at the base of
the ladder.
8. Once all the fasteners are tightened, install Nut Caps (76) on the concrete anchors.
Note: Be sure to apply anti-seize to all fasteners to prevent galling.
FIGURE CC
