S2Konnect N-2020SX
16
To test the adapter, proceed as follows:
1. Switch off the computer
2. If the computer is still connected to the data network, unplug the data cable from the network
adapter’s port.
3. Connect the network adapter as follows:
• For the simple test: Insert the protective plugs into the ports.
• For the loopback test: Insert the wrap plug into the port.
4. Boot to DOS.
Wait until the operating system is loaded and the DOS prompt is displayed.
5. You must select a driver containing the Diag Tool.
6. Start the diag program by:
7. Type “
yukondg
”.
8. Press <Enter>.
9. From the main menu of the diagnostics program, select one of the following:
•
DIAGNOSTICS
for the simple test (no loopback)
•
LOOPB. WRAP PLUG
for the loopback test
•
LOOPB. PORT TO PORT
for the port-to-port test (only with dual port adapters)
•
LOOPB. EXT. REPEATER
for the loop back repeater test
