50 39 490 3
Saab 9-5 5D
7 Make a hole for the wiring in the side trim’s stor-
age compartment as marked on the rear of the
trim. Also drill holes with a 4 mm drill bit for the
CD changer’s mounting screws as marked on
the rear.
8 Undo and remove the 4 transport screws
(2 coloured red on each short side) and place
them in a small plastic bag which can be handed
to the customer. Check that both mounting posi-
tion screws (1 on each side) are in the vertical
position (V).
9 Mount the CD changer in the side trim’s storage
compartment using the screws and washers
supplied. Connect the CD changer.
10 Fit the CD magazine.
11 Connect the diagnostics tool, select Audio Sys-
tem and the “Programming”menu. “Marry” the
CD changer to the car. This is a condition for
proper operation of the CD changer.
For operation of the CD changer, see the Own-
er’s Manual.
Important
If the CD changer is to be removed from the car
and refitted in the same car, the diagnostics tool
must be connected and the CD changer
"divorced" from the car via Audio System and the
“Programming”menu.
The CD changer must be divorced while connect-
ed to the car it was married to.
V
H
V
H
E930A058
8
9
9
9
7
7
7
